Bushnell 119598 Manual De Instrucciones página 14

camera could lockup if it is switched from ON to SETUP mode. If this occurs, simply move
the switch to OFF and then push it up to SETUP again.
SETUP Mode Shortcut Keys/Functions
As mentioned earlier in "Parts & Controls", five of the keys below the LCD have
secondary, "shortcut" functions when the camera is switched to SETUP mode
(but the MENU key has not been pressed):
• Press the UP key to quickly set the camera to shoot video clips.
• Press the DOWN key to quickly set the camera to take still photos.
• Press the RIGHT key to manually trigger the shutter. This is useful for
testing the camera-make sure you are in SETUP mode, press the RIGHT
key, and a few seconds later a photo or video (depending on how the
camera was set) will be saved to the SD card (or internal memory if no
card is inserted). The "number of images taken" counter on the top right
of the LCD will increase by one. If the display indicates "SD PROTECTED"
when you press the SHOT key, switch the camera OFF, remove the SD
card and slide its protect switch off.
• Press the LEFT key to snap and send a test photo. You will see a "Step"
display, followed by "Wireless test over!" and confirmation of wireless
communication (or error).
Fig. 3: SETUP Information Screen
Camera (Still Photo) Mode
Video Mode
14
Still Photo Mode
Time Stamp
Field Scan On
Battery Level
Video Sound On Video Resolution
Image Size
Cell Network
(Resolution)
Signal Strength
Available Video
Recording Time
Video Mode
# of Photos Taken
Remaining Photo
Capacity
SD Card Status