Bushnell 119598 Manual De Instrucciones página 19

change the minute for the Start time with UP/DOWN, then on to the
hour and minute settings for the Stop time.
5. After you finish setting the Stop minutes, press OK to confirm your
settings for the first block of Field Scan recording. If desired, you can
create a second block of time by pressing the DOWN key to select "B"
(Step 4), then press OK and follow the same process to set Start and
Stop times for Field Scan block "B" (Step 5). As an example of how you
might use these two available time blocks, you could setup Field Scan
time block "A" for the dawn hours from 6 AM to 8 AM, and block "B" to
capture images between 5:30 and 7 PM. No Field Scan recording would
occur from 8AM to 5:30PM, or from 7PM to 6AM.
6. After setting Start/Stop times to define Field Scan block "A" and/or "B",
press OK, then press the UP or DOWN key to select "Interval" and press
OK (Step 6). The Field Scan "Interval" setting lets you control how often a
photo or video clip is recorded during the block(s) of time you defined
with the Start and Stop settings. Your options are 60 minutes, 30 minutes,
15 minutes, 5 minutes (this is the default), or 1 minute (still photo mode
only). Use the UP/DOWN keys to select your preference, then press OK
to save it (Step 7). Note that for videos, "Interval" is independent of the
Length of each video recording-it's how often videos are recorded, not
how long each one lasts.
7. Here's an example of how the camera would operate, based on the
following Field Scan settings:
Field Scan: On
Field Scan A:
[Start]: 6:00
[Stop]: 8:00
Field Scan B:
[Start]: 17:30
[Stop]: 19:00
Interval: 15M
These settings would cause the camera to capture a photo (or video, if
the camera is set to that mode) once every 15 minutes, beginning at 6
AM, until the Field Scan "A" recording block stops at 8:00 AM. Later that
day, the camera would again take a photo or video every 15 minutes
between 5:30 PM and 7:00 PM (during Field Scan time block "B"). The
Note: avoid any "overlap" of Field Scan A & B
recording blocks when setting their start and
stop times, to assure correct operation. Also-if the
"Camera Mode" menu parameter is set to "Day" or
"Night" operation only, that will take priority
over your Field Scan settings. Set the Camera
Model to "24 HR" if you are setting both day and
night start and/or stop times in Field Scan.
19