KTM 60112092180 Manual Del Usuario página 5

6
7
8
9
A
Scope of delivery:
1x handlebar holder, premounted
4x round head screws M4x30
4x U washers M4, small
4x U washers M4, large
1x spacer plate
4x spacers POM
4x self-locking nuts M4
2x keys
Assembly
- Remove the nuts (1) and large U washers (2) and take off the clamps (3).
4
- Insert the key (4) into the lock and fold the detent (5) all the way down
toward the back.
3
- Open the locking lever all the way by turning the key.
1
2
5
The power supply unit must be aligned before the screws are tightened for
the locking function to operate properly. Align the power supply unit paral-
lel to one of the outer edges of the handlebar bracket (Figure C). Do not
tighten the screws excessively.
11
NOTE:
The clamping plate has already been prepared with various hole patterns
for holding different RAM mounts. To attach the plate, unscrew the clam-
10
ping plate and attach the RAM adapters using the M5 collar screws, M5
nuts and U washers.
B
- Screw the original power supply unit of the ZUMO660 to the handlebar
bracket (Figure A + B).
4x U washers M4, small (6)
4x round head screws M4x30 (7)
1x spacer plate (8)
4x spacers POM (9)
4x U washers M4, large (10)
4x self-locking nuts M4 (11)
C
5