GYS TITANIUM 400 AC/DC Manual De Usuario página 38

Cold weather
Pulse frequency
Downslope
End current
End duration
Post-gas
ADJUSTMENT TIPS : The choice of frequency
• If welding with manual metal input, then F(Hz) synchronized to the input gesture,
• If thin without supply (< 0.8 mm), F(Hz) > 10Hz
• Welding in position, then F(Hz) < 100Hz
TIG DC – Fast Pulse
This very high frequency pulsed current welding mode combines high current pulses (I, welding pulse) with low current pulses (I_Cold, part cooling
pulse). Fast Pulse mode allows to keep the arc constriction properties of Pulse mode at high frequencies but still on less unpleasant or even inau-
dible sound frequencies for the welder.
Settings Designation
Pre-gas
Starting current
Starting time
Rising current
Welding current
Cold weather
Pulse frequency
Downslope
End current
End duration
Post-gas
38
TITANIUM 400 AC/DC
20 - 80% Time balance of the warm current (I) of the pulsation
0.1 - 2500 Hz Pulse frequency
0 - 60 sec. Downslope current.
10 - 200 %
This stopping stop current is a phase after the current descent ramp.
0 - 10 sec.
Duration for which gas is released after the arc has stopped. It protects the weld pool
0 - 60 sec.
and the electrode against oxidisation when the metal is cooling down.
Adjustable
settings
0 - 60 sec. Time to purge the torch and to protect the area with gas before ignition
10 - 200 %
This starting bearing current is a phase before the current rise ramp.
0 - 10 sec.
0 - 60 sec. Current rise ramp.
3 - 400 A Welding current.
80% - 100 % Second welding current known as «cold» welding current
2.5 - 20 kHz Pulse frequency
0 - 60 sec. Downslope current.
10 - 200 %
This stopping stop current is a phase after the current descent ramp.
0 - 10 sec.
Duration for which gas is released after the arc has stopped. It protects the weld pool
0 - 60 sec.
and the electrode against oxidisation when the metal is cooling down.
Description & advice
EN