GYS TITANIUM 400 AC/DC Manual De Usuario página 45

Settings of a STEP :
Parameters Designation
STEP -
MODE Welding current mode
Activation of the
PULS
PULSE
AC waveform
Welding frequency
Percentage of pickling
Rising current
Welding current
Waveform
Cold current
Cold time
Pulse frequency
Duration of the step
* : the step duration setting
exit section to the last one.
the step duration setting allows in 4T mode and with a two-button torch only to switch from Step to press and release button 2.
The advanced settings (accessible in the process menu) :
Parameter
HF level
HF duration
Breaking voltage OFF, 0 - 50 V
Time to break 0 - 10 sec.
Bonding tension OFF, 0 - 50 V
Delay before gluing 0 - 10 sec.
TITANIUM 400 AC/DC
Settings
1 - 9 Selection of the STEP to be configured.
DC+ / DC- / AC Selection of the type of welding current of the Step.
ON / OFF Pulses the set current type.
AC waveform.
0.1 - 300 Hz Frequency of polarity reversals welding - pickling
20 - 80% Percentage of the welding period dedicated to pickling
Transition ramp between the current step value of the previous step and the current
0 - 60 sec.
step value.
3 - 400A Welding current.
Waveform of the pulsed part.
1 - 99% Second «cold» welding current
1 - 99% Time balance of the hot current (I) of the pulse
0.1 - 2.5 Hz Pulse frequency
, ,
Duration of the Step welding current or trigger mode (*).
0 - 90 min.
allows in 2T mode to manage the duration of the configured section at trigger release, the cycle will end from the
Setting
1 - 10 Index adjusting the voltage from 5 kV to 14 kV
0 - 3 sec. HF time before it stops
Upper arc voltage before stopping the welding generator
Duration of consideration of the breaking voltage
Lower arc voltage before stopping the welding generator (anti-sticking)
Duration of time for taking into account the bonding tension.
Description & advice
Description & advice
EN
45