Control Buttons / Lcd Display; Starting Your Watch (First Time); Important; Touch Navigation - Oregon Scientific SE336 Manual Del Usuario

CONTROL BUTTONS / LCD DiSPLAY

A. EL
1
2
3
4
5
B. MODE/-
1. : key tone deactivated
2. : key press prompt (touch EL) to activate backlight
3. : low battery indicator
4. : key press prompt (touch MODE/-)
5. : keypad locked
6. :key press prompt (touch +/ST/SP)
7. Time; heart rate measurements; mode banners;
exercise time / data
: key press prompt (touch ENTER)
8.
A. EL
C. +/ST/SP
1
2
6
3
7
8
4
5
D. ENTER
B. MODE/-
2
A. EL: Activate backlight
B. MODE/-: toggle between modes; exit current display and
return to previous screen; initiate search for HR signal;
decrease value of the setting; toggle setting options
C. +/ST/SP
C. +/ST/SP: start / stop stopwatch; increase value of the
setting; toggle setting options
D. ENTER: enter setting mode; confirm setting; toggle
through displays
6

STARTiNg YOUR WATCH (FiRST TiME)

7
To unlock the watch from sleep mode, tap 3 times on
8
the screen, then press and hold EL and ENTER
simultaneously until display appears. The watch will prompt
you to set your user profile. (Go directly to 'Set user profile'
section, step 4).

iMPORTANT

D. ENTER
• To ensure accurate calculations with your exercise,
you are strongly encouraged to set the watch and user
profiles before exercising.
• Remember to set the profiles after every battery
replacement or reset.
NOTE
When the watch is left idle for 30 seconds during
set up, it will automatically exit the setting mode and display
the time.

TOUCH NAVigATiON

This watch uses TOUCH screen technology – no clumsy
buttons. To navigate through functions, place finger on a
circle (each circle has a different function).