Sticker Plate Affixing Instructions - MarelliMotori MXB-E 180 Serie Manual De Instalación, Funcionamiento Y Mantenimiento

15. STICKER PLATE AFFIXING INSTRUCTIONS

Inside the terminal box there is an envelope containing the nameplate.
This nameplate must be affixed on the alternator as follow:
4. The sticker plate must be affixed at an ambient temperature of over 15°C.
5. Clean the relevant area (see fig. 1) with alcohol and wait until it is perfectly dry.
6. Remove the adhesive part from the support and apply it as shown in fig. 21, pressing it with a rubber
roller for better adherence.
All rights of translation,
adaptation, whether total or partial, by any means
(including photocopies
reserved.
963857252_=
reproduction and
and microfilms) are
Marelli Motori reserves the right to make any changes.
Fig. 21
53