ABB RVT Serie Instrucciones De Instalación Y De Funcionamiento página 590

Temperature probes commissioning
Each probe needs to be commissioned as per the following pro-
cedures before it can be used. Each probe has to be recognized
one by one:
• connect the probe to the temperature probe input (one probe
only)
• click on a row to assign a probe number
• click on the "Start" button
• the RVT recognize automatically the probe address
• restart the same procedure for each probe
When one of the probes has a problem, it can be cleared by
clicking the clear button. A unique address will be assigned to
each activated probe after the recognition completes.
Temperature probe auto recognition
—
s.a. ABB n.v.
Power Quality Products
Allée Centrale 10 Z.I. Jumet
B-6040 Charleroi (Jumet)
Belgium
Phone: +32(0) 71 250 811
Fax: +32(0) 71 344 007
Email: power.quality@be.abb.com
new.abb.com/high-voltage/capacitors/lv
—
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With re-
gard to purchase orders, the agreed par-
ticulars shall prevail. ABB does not accept
any responsibility whatsoever for potential
errors or possible lack of information in
this document.
We reserve all rights in this document and
Mechanical dimensions
Temperature Probes installation
Connect each probe successively
in the subject matter and illustrations con-
tained therein. Any reproduction, disclo-
sure to third parties or utilization of its
contents – in whole or in parts – is forbid-
den without prior written consent of ABB.
© Copyright 2018 ABB. All rights reserved.
Specifications subject to change without
notice.
- - -
T1 T2
D D D
Wire -
Wire D
Wire -
Wire D
T8