Össur ICEROSS SEAL-IN X5 Instrucciones De Uso página 7

Volume sock application:
• Pull the volume sock over the Seals and ensure it is placed level
between the two most proximal Seals.
• The volume sock can extend over the top two Seals as long as
suspension is maintained.
• Don the prosthesis as normal.
NOTE: Placing volume socks over the three distal Seals will result in loss
of suspension.
ICEROSS CLEAN & SIMPLE LUBRICANT SPRAY
®
Iceross Clean & Simple lubricant spray has to be used to facilitate
donning of the liner and the prosthesis.
The lubricant is designed to evaporate quickly after donning to maintain
maximum suspension. A spray pen accompanies the Seal-In Liner, small
enough to fit in a pocket and/or a handbag. It can be refilled with the
Iceross Clean & Simple lubricant spray.
WARNING: Do not apply to the skin. Avoid contact with eyes.
INGREDIENTS: Propanol and water.
ICELOCK EXPULSIONS VALVES
®
The Össur Icelock Expulsion Valves are designed and tested to
continually expel air when loading the prosthesis, thus maintaining
hypobaric suspension.
Product Number
L-551000
L-552000
ICEROSS DISTAL CUP
®
Iceross Distal Cups (I-3000xx) provide enhanced comfort for conical
limbs with poor soft tissue coverage. They can also be used as a fitting
tool in conjunction with the Iceross Original liners to ensure total contact
between the silicone and residual limb. The dermogel silicone in the
Iceross Distal Cup conforms to the limb, thus minimizing pressure over
bony prominence during gait.
To correctly f it a Distal Cup:
1. Measure the circumference of the residual limb at 4 cm from the
distal end. (Figure 1)
2. Choose the Distal Cup two or three sizes smaller than the
measurement
3. Roll the Distal Cup directly over the limb. (Figure 9)
4. When using an Iceross liner in combination with a Distal Cup, the
liner measurement (4 cm from the distal end) should be made with
the Distal Cup in place (i.e. over the Distal Cup). (Figure 10)
5. Choose the correct Iceross liner size based on the measurement
obtained with the Distal Cup in place (See LINER SIZING).
ICEROSS PADS (Figure 11)
®
Iceross Pads (I-6103xx) can be used to fill in any problem areas (i. e. voids
or scars) to ensure better fit and to minimize trapped air. Iceross Pads
may also be used to distribute body pressure and to protect the skin. In
some cases, custom-formed pads may be required for irregular shapes or
Description
Expulsion Valve 551
Expulsion Valve 552
Benef its
Small, cosmetic & easy
installation
Removable valve and large
smooth opening
7