Pin Assignment And Use Of I/O Port - Sony SNC-RZ30N Manual De Instalación

Pin Assignment and Use of
I/O Port
Pin assignment of I/O port
18 16 14 12
17 15 13 11
Pin Pin name
No.
1
Sensor In 1 –
2
Sensor In 1 +
3
Sensor In 2 –
4
Sensor In 2 +
5 Sensor In 3 –
6 Sensor In 3 +
7 Alarm Out 1 –
8 Alarm Out 1 +
9
Alarm Out 2 –
10
Alarm Out 2 +
11
GND
12
VDD (5 V)
13
GND (RS-232C/485)
14 Reserved
15
RXD (RS-232C)
16
TXD (RS-232C)
17
– TXD/RXD (RS-485)
18
+ TXD/RXD (RS-485)
26
GB
Specifications
10 8 6 4 2
9 7 5 3 1
I/O
Using the I/O receptacle
1
Insert a small slotted screwdriver into
the upper or lower slot of the hole you
want to connect a wire to (AWG No.
28 to 18). Hold down the screwdriver
and insert the wire, then release the
screwdriver.
1
Slotted screwdriver
2
Wire
3
Repeat this procedure to connect all
required wires.
2
Insert the I/O receptacle into the I/O
port on the rear of the camera, and
press upward the levers on both sides
to lock the receptacle.