Sony SNC-RZ30N Manual De Instalación página 9

Rear
18 16
17 15
6 7
(Ethernet) port
6
Connect to a hub or computer on the
10BASE-T or 100BASE-TX network
using an Ethernet cable (UTP, category
5).
Caution
When using a LAN cable: For safety, do
not connect to the connector for
peripheral device wiring that might have
excessive voltage.
T (video output) connector
7
(BNC type)
Outputs a composite video signal.
Connect to a composite video input
connector of a video monitor, VCR, etc.
Note
This camera is designed so that the
monitoring image is shown upright
when the camera is mounted on the
ceiling. When the camera is on the
desktop, therefore, the monitoring image
is shown upside down.
8 I/O (Input/Output) port
This port is provided with RS-485 or
RS-232C port, three sensor inputs and
two alarm outputs.
The RS-485 or RS-232C port is used
when you connect peripheral devices to
the camera using the RS-485 or RS-
232C interface, and control the devices
from the computer or receive data from
the devices via the network.
14 12 10 8 6 4 2
13 11 9 7 5 3 1
!
DC IN 12V
8 9 q;
Location and Functions of Parts and Controls
The sensor inputs are used to
synchronize the camera operation with
E-mail or other applications.
The alarm outputs are used to control the
connected peripheral devices by
synchronizing with an external sensor
input, the built-in activity detection
function, a manual trigger button, the
Day/Night function or the timer
function.
For details on each function and
required settings, see the User's Guide
stored in the supplied CD-ROM.
For the pin assignment and wiring, see
"Pin Assignment and Use of I/O Port"
on page 26.
9 DC IN 12 V (power input)
connector
Connect the supplied AC power adaptor.
q; Reset switch
To reset the camera to the factory default
settings, hold down this switch and
supply the power to the camera.
9
GB