Homelite F2015 Manual De Utilización página 20

GB
F D E
SPECIFIC SAFETY RULES FOR TRIMMER USE
Make sure all guards, straps, deflectors and handles
■
are properly and securely attached.
Use only the manufacturer's replacement line in the
■
cutting head. Do not use any other cutting attachment.
Never operate unit without the safety guard in place
■
and in good condition.
Maintain a firm grip on both handles while trimming.
■
Keep bump head below waist level. Never cut with
the bump head located over 76 cm or more above the
ground.
SPECIFICATION
Weight
- Without fuel and string head
- Without fuel with string head
Fuel tank volume
Cutting swath
Engine displacement
Maximum engine performance
(in accordance with ISO 8893)
Maximum rotational frequency
of the the spindle
Engine speed (rotational frequency)
at recommended max. spindle
rotational frequency
Engine speed (rotational frequency)
at idle
Fuel consumption (in accordance
with ISO 8893) at max.
engine performance
Specific fuel consumption
(in accordance with ISO 8893)
at max. engine performance
Vibration level idling
- Front handle
- Rear handle
Vibration level racing
- Front handle
- Rear handle
Sound pressure level
(in accordance with EN ISO 11806:1997,
ISO 7917:1987)
Sound power level (in accordance
with ISO 10884)
I P NL S DK
4.26 kg
4.45 kg
425 cm
432 mm
22 cc
0.75 kW
9,000 min-
12,500 min-
3,100-4,300 min-
0.48 kg/h
0.46 kg/h
4.8 m/s
4.8 m/s
13.0 m/s
8.4 m/s
100 dB (A)
112 dB (A)
N FIN GR HU CZ RU
English
DESCRIPTION
1. Starter Grip
2. Front Handle
3. Shaft
4. Throttle
5. Safety Guard
6. Trimming Line
7. Bump Head
8. On / Off Switch
9. Throttle Control & Rear Handle
10. Muffler Guard
11. Choke Lever
12. Bolt
13. Bracket
14. Wing Nut
15. Lock Washer
16. Flat Washer
17. Mixture Needle
3
18. Rear Housing
19. Screws
20. Bent End of Muffler Guard
21. Opening In Rear Housing
22. Torx Wrench
23. Dangerous Cutting Area
1
24. Best Cutting Area
25. Direction Of Rotation
26. Throttle Interlock
1
27. Primer Bulb
28. Idle Speed Screw
1
29. Run Position
30. Half Choke Position
31. Choke Position
32. Bump Knob
33. Slots
34. Eyelets
35. Shaft Of Bump Head
36. Spring
2
37. First Line
2
38. Anchor Hole
39. Arrows On Spool
40. Spool
2
41. Latch
2
42. Cover
43. Filter
44. Air Filter Cover
45. Fuel Cap
46. Second Line
13
RO PL SLO HR TR EST LT LV SK BG