Safety Equipment; Before Use; Attaching The Round Handle; Fitting The Quick Release Mechanism - FLORABEST FBK 4 A1 Traducción Del Manual De Instrucciones Original

Safety equipment

The relevant plastic protective guard for the cutting blade or filament
operation must be installed when working with the appliance in order to
prevent objects from being flung away.
WARNING!
■ Never mow/trim while other individuals, especially children or animals,
are in the vicinity.
■ Maintain a safety distance of 15 m. Turn off the appliance immedi-
ately if this distance is not maintained.
CAUTION! RISK OF POISONING!
■ Exhaust gases, fuels and lubricants are toxic. Exhaust gases must
never be inhaled.
WARNING!
■ Petrol is highly flammable. Store petrol only in the containers
provided.
■ Refuel only outdoors and do not smoke.
■ The filler cap must not be opened and refuelling must not take place
while the engine is running or when the appliance is hot.
■ Do not attempt to start the engine if the petrol has overflowed. In-
stead, remove the appliance from the area polluted by petrol. Do not
attempt to restart the appliance until the petrol fumes have dissipated.
■ For safety reasons, the petrol tank and filler cap must be replaced if
they are damaged.
Limit the noise development and vibrations to a minimum!
■ Only use appliances that are in good condition.
■ Maintain and clean the appliance on a regular basis.
■ Adapt your working method to the appliance.
■ Do not overload the appliance.
■ Have the appliance inspected if necessary.
■ Switch the appliance off when not in use.
■ Wear protective gloves!
FBK 4 A1

Before use

CAUTION!
■ Always wear non-slip footwear and appropriate safety clothing
such as protective gloves, a hard hat, a protective mask and safety
goggles as well as hearing protection.
■ Check the area in which the appliance is to be used and remove any
objects that may be caught and slung away.
■ Before use and after dropping or other impacts, always visually in-
spect the appliance to check whether the cutting tool, mounting bolts
and the entire cutting unit are damaged. Worn or damaged cutting
tools and mounting bolts must be replaced.
■ Always carry out a visual inspection before use to check whether the
cutting tools are worn or damaged. To prevent imbalance, worn or
damaged cutting tools and mounting bolts should be replaced only
as complete sets.

Attaching the round handle

♦ Start by fitting the rubber ring
♦ Attach the barrier bar onto the rubber ring
♦ The pin on the barrier bar
5
b
holes on the boom to lock it into place.
♦ Push the round handle onto the rubber ring
boom .
♦ Insert the 4 mounting bolts
and secure them with the 4 nuts in the barrier bar
♦ Tighten the bolts .

Fitting the quick release mechanism

♦ Hook in the carabiner and secure it with the red strap on the quick
release mechanism (see figures). Pull on the red strap if you have to
release the appliance quickly.

Fixing/attaching the carrying harness

6@
♦ Hook the carrying harness
♦ Adjust the length of the carrying harness
carrying lug is at hip height when hooked in place.
on the boom .
5a
from below.
5a
must be pushed into one of the two
provided on the
5a
from above through the round handle
.
into the carrying lug .
6@
to your size so that the
GB
MT
63