Conformity Declaration - Rupes LHR21III Instrucciones De Uso Y Anutencion

Ocultar thumbs Ver también para LHR21III:

Manual de instrucciones (21 páginas)

página de 60

/ 60
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

of the tool; if the tool is to be locked in the ON position,

press button (11) at the same time and keep it pressed while

releasing lever (2), thus locking the switch.

- Stopping: release the lever of the switch or, if locked in

position, push the lever to release the lock button.

The tool continues to rotate after it is turned off.

Do not empty the tool with the polishing pad still

mounted. In this way, the polishing pad may be subject

to lacerations

SELECTING RPM

The speed can be adjusted in two ways: by means of the

variable actuation switch (2), by means of the adjustment

wheel fitted on the upper part of the machine (3). Adjustment

by means of the wheel (3) affects the adjustment made using

the variable actuation switch (2), determining the maximum

speed of the motor. The speed must be selected according to

the characteristics of the pads and those of the material to be

machined.

ACCESSORIES DISASSEMBLY

BACKING PAD

Unscrew pad's (4-9) mounting screw using the wrench (10).

POLISHING FOAM

Remove the polishing foam used and apply the new one with

pressing on the backing pad (9).

ALLOWED ACCESSORIES

LHR 21III: polishing foam Ø 180 mm for backing pad Ø 150 mm.

LHR 15III: polishing foam Ø 150 mm for backing pad Ø 125 mm.

NOISE EMISSION VALUES

Detected noise emission values comply with the following

directives:

EN 62841

SOUND PRESSURE LEVEL

SOUND POWER LEVEL

UNCERTAINTY

Use ear protection!

VIBRATION EMESSION VALUES

Detected vibration emission values comply with the following

directives:

EN 62841

3 AXIS VIBRATION LEVEL

UNCERTAINTY

Displayed emission values are comparative and are to be

employed for a provisional assessment of the operator's risk

exposure during the work period. Appropriate evaluation of

work period must also include tool's idle and stop periods.

These emission values represent the tool's main applications.

If the tool is used for other applications, with other accessories,

or if it does not undergo regular maintenance, emission values

can significantly increase during operations.

III

LHR 21

dB(A)

78.5

dB(A)

89.5

III

LHR 21

m/s

3.65

0.40

Danger! The indicated measurements refer to new

power tools. Daily usage causes the noise and vibration

values to change.

MAINTENANCE

All maintenance operations are carried out with the power

supply disconnected.

At the end of each work session, or when required, remove any

dust from the body of the tool using a jet of compressed air,

paying particular attention to the motor ventilation slots.

No other maintenance operations must be undertaken by

the user.

Maintenance and cleaning of the inner parts, like brushes, ball

bearings, gears etc. or others, must be carried out only by an

authorized customer-service workshop.

DISPOSAL (WEEE DIRECTIVE)

For EC countries only: According to the European

Directive on Waste from electrical and electronic

equipment and its implementation in conformity

with national standards, exhausted electrical equipment

must be collected separately, in order to be recycled in an

environmentally friendly way. The product, when it reaches

the end of its life, must not be dispersed in the environment

or thrown away as household waste. It must be disposed at

authorized recycling centres (contact your local authorities to

know where to dispose of the product according to the law).

The correct disposal of the product contributes to the health

and preservation of the environment.

Illegal disposal of the product will entail penalties against the

offenders.