Siemens SINUMERIK 840D sl Manual De Puesta En Servicio página 123

Active tool in channel 1 changed to T0, D1
Mode: AUTO Program: running Channel: active
Program-Level information:
Level Program Invoc Offset
running:
1 /_N_MPF_DIR/_N_RALF_MPF 1 5
stopped:
1 /_N_MPF_DIR/_N_RALF_MPF 1 #
Actual Block:
t0
x1
t1
Number of Machine axis: 5
Increment: continous Increment
MCS-Name Position DistToGo
X1 1.000 0.000
Y1 0.000 0.000
Z1 0.000 0.000
A1 0.000 0.000
B1 0.000 0.000
WCS-Name Position DistToGo Position ENS DistToGo ENS
X 1.000 0.000 1.000 0.000
Y 0.000 0.000 0.000 0.000
Z 0.000 0.000 0.000 0.000
A 0.000 0.000 0.000 0.000
B 0.000 0.000 0.000 0.000
Feed Rate: 0.000 Set: 0.000
Spindle Rate: 0.000 Set: 0.000
Actual Tool T0, D1, Type 0
Geometry -- tool type 0
Geometry -- tool point direction 0.000
Geometry -- length 1 0.000
Geometry -- length 2 0.000
Geometry -- length 3 0.000
Geometry -- radius 0.000
Geometry -- corner radius 0.000
Geometry -- length 4 0.000
Geometry -- length 5 0.000
Geometry -- angle 1 0.000
Geometry -- angle 2 0.000
Wear -- length 1 0.000
Wear -- length 2 0.000
Wear -- length 3 0.000
Wear -- radius 0.000
Wear -- slot width b 0.000
Wear -- proj. length k 0.000
Wear -- length 5 0.000
Wear -- angle 1 0.000
Wear -- angle 2 0.000
Puesta en marcha de HMI Embedded sl
Manual de puesta en servicio, 11/2006, 6FC5397-8CP10-0EA0
Diagnóstico
8.1 Registrador de acciones
117