Parker Controller Family Manual De Uso página 105

This value indicates the position for 0%.
SEt0
The 0% point is always set from the top edge of the tank in
mm.
Not activated if unit = %
Reset if unit = mm/inch
This value indicates the position for 100%.
SEt1
The 100% point is always set from the top edge of the tank in
mm.
Not activated if unit = %
Reset if unit = mm/inch
Configuration of analogue outputs.
AnA
0-20 = 0-20mA
4-20 = 4-20mA
Deleting the minimum and maximum values in memory.
rES
YES = yes, clear memory now
no = no; do not clear memory now
Programming switching output 2 as the error output.
Err
YES = yes
no = no
Indicate software version.
SVn
Choice of sensor length.
tYPE
This menu option is only activated when the display unit is con-
nected by cable with the sensor.
Specifies the duration in seconds of the period of oscillation of
FILT
the level that should be filtered out.
The end of programming mode.
End
105