Programming Mode - Parker Controller Family Manual De Uso

9.4

Programming mode

In programming mode, parameters are changed and then permanently
saved. No power supply is needed to keep the saved data in the EEProm
memory.
To ensure trouble-free operation, the switch remains in run mode
internally. If no key is pressed in 30 seconds, the switch changes
automatically back to run mode.
Activation of programming mode.
Caution
To prevent unintentional changes of program parameters, the
programming mode can only be activated by the following key
combination: keep one of the arrow keys
at the same time press Enter
Password protection
To prevent unauthorised changes from being made to parameters, the
programming mode can be protected with a password.
When a password has been programmed in, PAS appears. The password
is entered with the arrow keys
The switch can then be programmed.
If no password is set (Passwort = 0000), then the pressure switch can be
immediately programmed.
. ProG appears.
or and then confirmed with Enter
or pressed down,
.
109