Parker Controller Family Manual De Uso página 99

Programming switching output 2 as the error output.
Err
YES = yes
no = no
Indicate software version
SVn
Setting the decimal places.
dPP
0000 = no decimal place
000.0 = one decimal place
The end of programming mode.
End
Error displays
The set value is lower than the other respective parameters.
Att1
Press Enter
rSP and froM, to).
Device electronics defective. Please send in for repair.
Err1
Nominal device temperature / measuring range has been
Err3
exceeded. Analogue electronics defective.
Please check system temperature!
If error persists, please send device in for repair.
to adjust the smaller value (see menu point SP,
99