mabe IWO19JSPFFS Instrucciones Y Advertencias página 8

INSTALLATION INSTRUCTIONS
WARNING
To avoid a hazard due to instability of the appli-
ance, it must be fixed in accordance with the
instructions.
INSTALLATION OF ANTI-TIP
3
SUPPORT
Wall and floor construction in WOOD:
A
• Drill the appropriate number of 3mm holes
in the center of each floor support hole that
is being used (a nail or punch can be used if
a punch is not available).
• Install the anti-tip floor support by tightening
the 2, or preferably 4, #10-16 x 38mm (1
1/2") hex head screws into place as shown in
Figure 3.
Figure 3 - Wall and floor connection
2 screws
Rear right
end of the
fridge
B Concrete wall and floor construction
• Required Anchors (not included): 4 for each
¼" x ¼" (6,350 mm) x 38,100 mm (1½")
hex head 4 for each 3/8" (9,525 mm) outside
diameter anchor
• Drill holes of the recommended size for
anchors in concrete in the center of the holes
marked in Step 2.
• Install the anchors into the drilled holes.
Place the anti-tip floor support as outlined in
Step 2.
• Install the anchor bolts through the anti- tip
floor bracket and tighten properly.
C
Construction of WOOD wall and ceramic
floor
• For this special case, locate the 2 wall holes
identified in Fig. 1.
8
Wall
They must
Floor
go in a Wall
or metal base
plate
Floor
C Drill a 3 mm pilot hole at an angle (approx. as
shown in Fig. 3) in the center of each hole.
• Install the anti-tip floor support using the
minimum acceptable installation #1, as
shown in Fig. 2.
HOW TO POSITION THE REFRIG-
4
ERATOR TO OPERATE THE
ANTI-TIP DEVICE AND THE BASE
OF THE BRACKET.
Before putting the refrigerator in place, plug
A
the power cable into the power outlet and
connect the water line (if applicable) - Check
for leaks.
Locate the left side of the refrigerator and
B
move it back approximately in line with the left
side of the opening where your refrigerator
will be placed W. This should position the
anti-tip floor bracket so that the anti-tip floor
bracket can be connected to the refrigerator.
NOTE: When positioning the refrigerator,
make sure that the mark on the floor
Wall
matches the left side of the refrigerator.
Carefully slide the refrigerator into the cabinet
C
opening until it comes to a complete stop.
Check that the front of the refrigerator is
aligned with the front of the cabinet. If not,
gently swing the refrigerator back and forth
until it hooks and you notice that the refrigera-
tor is fully supported by the rear wall.
OPTIONAL D: Adjust the rear (and front) wheel
D
height settings to fully engage the rear anti-tip
brackets, while also aligning the front of the
refrigerator with the front of the cabinet.
NOTE:
If you separate the refrigerator from the
wall for any reason, make sure that the
anti-tip floor bracket is engaged when the
refrigerator is placed back against the wall.