GLOBBER ONE K 125 Manual Del Propietário página 7

Assembling the product
- The folding and unfolding operations of the scooter are to
be done by a single person.
- During these operations, be careful you do not get your
fingers stuck in the hinge and locking system.
- Make sure that the locking devices are properly engaged.
Warning! Risk of injury by pinching!
Do not insert your fingers into the shaded
area indicated in the image.
1 - Unfold the scooter
Step 1: Unpack the folded-up scooter from its box.
Step 2: One hand is pressing down on the rear brake and
the other hand pulls away the bar from rear brake . Unfold
the handle and front wheel upwards until the automatic lock
secures the T-bar handles in upright position.
Step 3: Open the clamp lever on the T-bar. Pull out both
parts of the T-bar handle from the double clips. Press in the
spring-loaded buttons and insert both into the tube of the
T-bar. Wiggle and turn a bit until their spring-loaded buttons
align with the holes and fix the whole steering bar assembly
in place. Close clamp lever.
2 - Adjust the handle bar
Open the clamp. Then press the spring-loaded button and
pull the handlebar up or push it down with the other hand.
Choose the suitable locking hole and make sure the spring-
loaded button snaps securely in place. The adjustable T-bar
handle can be adapted in height to suit the rider.
Three different positions are available.
Lock the clamp tight and securely when you have finished
adjusting the height.
3 Positions:
• Low position: 85.5 cm
• Middle position: 90.5 cm
• High position: 95.5 cm
7