Cleaning Of Machine Oil Tank; Check-Up Of Spark Plug - Serpento DEFENDER Manual De Usuario Y Mantenimiento

• DEFENDER
MANUAL DEL USUARIO

Cleaning of Machine Oil Tank

(1) Drain off all the run-in machine oil from the oil tank.
(2) Dismount the related parts.
(3) Wash clean all the related parts.
(4) Fill in the required oil.
* This job should not be done by untrained persons but shall be done at an authorized service center.
Screw plug for oil draining

Check-up of Spark Plug

(1) Remove the cap of spark plug and screw off the spark plug by the plug wrench.
(2) Clean the spark plug all around or replace it if it is corroded or there is too much deposit on it.
(3) Regulate the gap of the spark plug to 0.6- 0.7mtn.
(4) The spark plug of the designated type should be used. The applicable type of spark plug: NHSP LD D8RTC made in China.
29