Domo DO-324A Manual Del Usuario página 61

INSTALLATION OF THE WINDOW KIT
The air outlet hose must be used in the "cool" or "auto"
mode. During the "fan" or "dry" mode, you don't need to
attache the air outlet hose.
- Place the round ring with small air outlet on the air
outlet hose.
- Place the window kit in your window. This can be
used horizontally or vertically. Block the window
kit on the desired length, with the supplied bold.
- Use the window seal to close up any gaps between
the window and the window kit.
NOTE : Make sure the air outlet hose isn't bend during use.
Make sure there is a free surrounding of at least 50 cm
around the outlet.
INSTALLATION WALL KIT
The air outlet hose must be used in the "cool" or "auto"
mode. During the "fan" or "dry" mode, you don't need to
attache the air outlet hose.
- Make an opening in the wall the size of the wall
adapator.
- Place the wall adaptor in the opening.
- Place the round ring on the air outlet hose.
- Place hose with the round ring on the wall adap-
tor.
NOTE : Make sure the air outlet hose isn't bend during use.
Make sure there is a free surrounding of at least 50 cm
around the outlet.
DRAINING
During the "dry" mode you can use a permanent drainage.
- Remove the permanent drain plug.
- Attache the drain hose on the permanent drain.
- Make sure the water is drained in a save and permanent way.
When you don't use the permanent drain, the non recycled condesation
water, will be stored in the water tank.
- When the water tank is full a few beep signals will be heard
and on the display the code P1 will appear. The "cool" or
"dry" mode will end automatically. The fan will continue to
operate, this is normal.
61
DO-324A