Symbols On The Device; Preparation; Initial Startup - Starmix NTS eCRAFT L-1422 Instrucciones Para El Manejo

Air exit, working air
3
Suction head
4
Suction head lock
5
Dirt receptacle
6
Steering roller
7
Recessed grip
8
Air inlet, motor cooling air
9
Suction hose port
10
Floor nozzle
11
Suction pipe
12
Main switch
13
Carrying handle
14
Hose fastener
15
Float
16
Angle piece
17
Cartridge filter (PES)
18
Securing nut
19
Suction pipe holder
20
Holder for crevice nozzle
21
Type plate
22
Cable hooks
23
Mains cable
24

Symbols on the device

Dust class
WARNING: This device contains dusts that are harmful
to your health. Emptying and maintenance, including
removal of the dust bag, may only be performed by ap-
propriately trained personnel wearing suitable personal
protective equipment. Do not switch on until the entire
filter system is installed.
Cartridge filter
Cartridge filter (PES)
Order number

Preparation

1. Unpack the device and install the accessories.
Illustration B
Danger from dust that is harmful to your health
Respiratory sicknesses through inhalation of dust.
Do not vacuum without correctly installed filter ele-
ments, otherwise a danger to health from increased fine
dust emission is present. Therefore, the cartridge filter
must always be attached when vacuuming.
ATTENTION
Danger due to fine dust entering
Risk of damage to the suction motor.
Never remove the cartridge filter when vacuuming.
● The appliance is fitted with a fleece filter bag with
Note
All types of dust up to dust class L can be vacuumed
with this device.
Note
The device is an industrial vacuum cleaner for vacuum-
ing dry, non-inflammable dusts with workplace limit val-
ues (AGW) greater than or equal to 1 mg/m
● When vacuuming up fine dust, it is recommended to
1. Unlock and remove the suction head.
2. Fit the fleece filter bag.
3. Fit and lock the suction head.
Danger from dust that is harmful to your health
Respiratory sicknesses through inhalation of dust.
No dusts harmful to health may be vacuumed when per-
forming wet vacuum cleaning.
1. Remove the brush strip.
2. Install the squeegees.
Note
The structured side of the squeegees must face out-
wards.
● The fleece filter bag must always be removed when
1. Unlock and remove the suction head.
2. Pull the fleece filter bag on the flange up and out.
3. Fold in the lock latch and seal the fleece filter bag
4. Dispose of the used fleece filter bag in accordance
5. Fit and lock the suction head.
454856
On completion of wet vacuum cleaning: Dry the car-
tridge filter. Clean the container with a moist cloth and
dry it off.
The suction hose is equipped with a clip system. All ac-
cessory parts with a nominal width of 35 mm can be
connected.
Illustration F
English

Initial startup

WARNING
Dry vacuuming
lock latch, order no. 454870 (5 pieces).
use an additional fleece filter bag.
Installing the fleece filter bag
Illustration C
Wet vacuum cleaning
DANGER
Installing the squeegees
Illustration D
Removing the fleece filter bag
vacuuming wet substances.
Illustration E
tight.
with statutory regulations.
General
Clip connection
3
.
9