Omnifilter K2 Manual Del Propietário página 2

INSTALLATION INSTRUCTIONS
ON 3/8" COPPER TUBING USING
THE OMNI SINK KIT:
There are many ways to install your OMNI
Under-Sink Water Filter into a water line.
These instructions are for use with the
Omni Sink Kit.
1. Locate and turn off the main water supply
valve and open a faucet to drain the system.
See Figure 1.
Locate and
close the
cold water
inlet valve
3" minimum vertical
clearance required
Figure 1
2. Position the filter housing bracket on the wall
of the cabinet nearest the cold water line
beneath the sink. Leave a 3" minimum clear-
ance between the bottom of the filter hous-
poly tubing
bracket
3/8" to 3/4"
compression fitting
brass nuts
brass inserts
brass union
brass ferrules
plastic insert
screws
Figure 2
ing and the floor of the cabinet. Use a pencil
to mark the bracket slots on the wall.
3. Drill a 1/8" hole at each of the two marks,
install the drywall anchors (can be purchased
locally) and insert the mounting screws. Leave
each screw head 1/4" out from the wall.
4. Empty the OMNI SINK-KIT box and identify all
of the components. See Figure 2.
5. Attach the mounting bracket to the filter
head. See Figure 3.
Bracket
3/8" to 3/4"
Threaded
Compression
Fitting
Figure 3
6. Install one of the threaded compression fit-
tings into the "In" port of the filter head and
one into the "Out" port of the filter head.
Tighten the fittings with a wrench.
NOTICE: The poly tubing will wear with
time. Replace tubing if necessary. The "IN"
and "OUT" ports are marked on the top of
the filter head.
7. Cut the cold water line with a tube cutter
and gently bend and separate the water
lines. See Figure 4.
Cut and gently bend
the copper water line.
Figure 4
2
"Head" Portion
of Filter Housing
"Sump" Portion
of Filter Housing