English
T-EP REMOTE CONTROL
•
INTRODUCTION
This unit was designed for the remote control of con-
trolled mechanical ventilation units.
The control panel features a Main Screen
that offers access to two setting submenus:
1. USER Settings Menu where the
user can select the operating mode and set
the clock;
2. TECHNICAL Settings Menu where the installer
can calibrate the flow rate, change the standard
unit operating parameters, set functions and
monitor the operating state.
On the main screen, the user can view alarm
reports and readings of the environmental tem-
perature and humidity.
The USER Settings Menu offers these options:
1. Manual selection of preset ventilation speed:
a) Party Mode- Intensive timed ventilation
b) Holiday Mode - Permanent or customised An-
ti-mould ventilation
2. Activation/deactivation of Automatic Mode.
An icon indicates activation of "Automatic Mode".
3. Customised selection of desired air flow rate
in manual mode:
a) 100% - Nominal ventilation (standard)
b) 70% - Reduced ventilation (nighttime)
c) 45% - Humidity Control for High Humidity Rate
Environments
d) 25% - Humidity Control for Low Humidity Rate
Environments
4. Voluntary activation of free-cooling mode.
5. Weekly Programming
86
The MAIN SCREEN features the following op-
tions:
1. Indication of the activation of the Weekly Pro-
4
gram
.
2. The preheating icon indicates activation of
Antifreeze Mode.
3. A timed warning icon is activated to suggest
replacing the filters.
4. A bypass icon indicates the activation of the
free-cooling mode.
DAY
The TECHNICAL Menu offers these options:
1. Possibility of confirming or editing the oper-
ating parameters and functions.
2. Monitoring of work conditions.
3. Set the fan calibration design flow rates.
4. Input and Selection of the Weekly Program
available to the user.
5. Configuration of dry contacts, relays and Mod-
bus parameters
4
Indoor Air
Temperature
Display
°C
-