Technical Data; Safety Features; Spare Parts - SKF 729659 C Instrucciones De Uso

2.1 Technical data

Voltage
Power
Temperature range
Temperature accuracy
Plate dimensions
Height of lid
Outside dimensions
Length of connection cable
Weight
Designation
3. Operating instructions
a) Make sure the voltage marked on the heater corresponds with the one available from
the main supply.
b) Connect the heater to the power supply. For certain markets the correct plug might
have to be attached in order to it the electrical socket.
c) Set the thermostat to the required temperature. Recommended temperature for
bearings is 110 °C (230 °F).
d) Turn the unit on by pressing the ON/OFF switch. Main pilot lamp will light up.
e) The second pilot lamp is lit while the hot plate is being heated but switches off as soon
as the selected temperature has been reached.
f) The temperature of the hot plate will remain within 10 °C (18 °F) of the selected
value.

4. Safety features

For increased safety the SKF hot plate is equipped with overheating protection. This will
automatically switch off the power in case of thermostat failure.

5. Spare parts

Designation
729659 C–1
SKF 729659 C
230 V, 50/60 Hz or 115 V, 50/60 Hz
1 000 W
50 – 200 °C (120 – 390 °F)
better than 10 °C (18 °F)
380 ™ 178 mm (15 ™ 7 in.)
50 mm (2 in.)
400 ™ 240 ™ 130 mm (16 ™ 10 ™ 5 in.)
2 m (6.6 ft)
4,7 kg (10 lb)
729659 C (230 V model)
729659 C/110V (115 V model)
Description
Heating plate, incl. thermostat and overheating protection
5