Technical Data; Installation Of The Mains Plug - SKF TIH 220m Instrucciones De Uso

ЗАО "Берг АБ"

2.2 Technical Data

TIH 220m/xx
Voltage (±10%):
Recommended line protection:
Power consumption (maximum)
Temperature control
Probe type
Probe maximum temperature
Time mode
Power range
Demagnetisation
Overall dimensions (w x d x h)
Area between supports(width x height)
Coil diameter
Weight (with yokes)
Workpiece maximum weight
Maximum heating temperature
m *
20
Standard yoke dimensions:
70 x 70 x 430 mm (2,8 x 2,8 x 16,9 in)
40 x 40 x 430 mm (1,5 x 1,5 x 16,9 in)
* m represents the weight (kg) of the heaviest SRB 231 bearing that can be heated from
20
20 to 110 °C (68 to 230 °F) in 20 minutes.

3. Installation of the mains plug

A qualified electrician must install a suitable mains plug. The correct supply voltage is
shown in section 2.2.
The wires should be connected as follows:
TIH 220m/MV, TIH 220m/LV with 200V-3 phases, and all other three phases supply
execution
Colour of TIH 220m/xx wire
yellow / green
blue
brown
Connect the TIH 220m to only two of the three phases.
8
(495) 727-22-72
TIH 220m/MV:
TIH 220m/LV:
TIH 220m/MV
TIH 220m/LV
promshop- biz@ya.ru
400-460V / 50-60Hz
200-240V / 50-60Hz
minimum requirement 25 A
minimum requirement 50 A
10,0-11,5 kVA for 400-460 V
0-250 °C (32-482 °F); in steps of 1°
thermocouple, K type
250 °C (482 °F)
0-60 minutes; in steps of 0.1 minute
100%- 50%
automatic; residual magnetism <2A/cm
750 x 290 x 440 mm
(29,5 x 11,4 x 17,3 in)
250 x 255 mm (9,8 x 10,0 in)
140 mm (5,5 in)
For minimum bearing bore diameter of
150 mm (5,9 in)
86 kg (189 lbs)
Bearing: 300 kg (661 lbs)
Solid component: 150 kg (330 lbs)
approx. 400 °C (752 °F)
220 kg (bearing 23172)
For minimum bearing bore diameter of:
100 mm (3,9 in)
60 mm (2,3 in)
Mains supply terminal
ground
phase 1
phase 2
www.promshop.biz
SKF TIH 220m