Control Panel; Channel Select - Fender Machete Instrucciones De Funcionamiento

A . INPUT — Plug your guitar in here.
+/– — Press to activate 6dB of input attenuation as indicated
B .
by the button LED. This provides cleaner response when used
with pre-amplified or high-output instruments.
C . GAIN — Adjusts the channel one preamp gain level. Pull this
knob out for additional channel one high-frequency preamp
response.
D . VOLUME — Adjusts the channel one volume. Pull this knob out
to select the "Channel One Boost" channel for an extra boost of
preamp gain; also switchable from the Machete footswitch or
by using MIDI commands.
If the footswitch or MIDI is used to select the channel one
gain boost, the in/out position of the VOLUME knob may not
accurately indicate whether the channel one boost is selected.
The "CHANNEL ONE GAIN BOOST" LED on the footswitch will
always light up when the channel one boost is active.
E . LOW / MID / HIGH — Adjusts the channel one tone.
Connect either jack on
the footswitch to the
FOOTSWITCH jack {Z}
on the rear panel of the
amplifier using the sup-
plied cable to enable the
remote footswitch func-
tions described below.
Press to switch channels, instead
of using the control panel CH 2
switch {K}.
• CONTROL PANEL •
• FOUR-BUTTON FOOTSWITCH •
Press to switch the channel one
gain boost on/off, instead of pulling
out the VOLUME knob {D}.
F . NOTCH — Adjusts the channel one mid-frequency attenuation
for a variety of American and British tonal flavors:
FREQUENCY
Treble
Emphasis
G . GAIN — Adjusts the channel two preamp gain level.
H . VOLUME — Adjusts the channel two volume.
I . LOW / MID / HIGH — Adjusts the channel two tone.
J . NOTCH — Adjusts the channel two mid-frequency attenuation
for a variety of American and British tonal flavors.
K . CHANNEL SELECT — Press to switch between channel one
and channel two. Illuminates when channel two is active.
L . REVERB — Adjusts the reverb level for both channels.
M . DAMPING — Adjusts speaker damping, or the resonance
interaction between the power amplifier and the speaker.
N . POWER INDICATOR — Illuminates when power is on to the unit.
Press to switch the effects
loop on/off.
Bass
Emphasis
You can connect the
"open" jack to a second
Machete footswitch (op-
tional) to enable identical
footswitch functions from
two remote locations!
Press to switch the reverb
effect on/off.
7