Before And After Fitting; Assembling; Activating; Charging - signia Pure Charge&Go X Guía Del Especialista

Before and after fitting
You have to prepare the hearing instruments before you
can start fitting.

Assembling

A power cell is installed in every hearing instrument on
X
delivery. There is no need to insert a battery.
Attach a suitable ear piece to
X
the suitable receiver unit.
Attach the receiver unit to the
X
hearing instrument by clicking
it in place.
Push the receiver locking bar
X
into the housing.

Activating

Before first use or first fitting you have to activate the
hearing instruments by putting them into the charger.
Wait until the first orange LED lights up.
Note:
●
Hearing instruments that are activated and not used
may discharge faster than hearing instruments that
have not been activated. Only activate the hearing
instruments before first use or first fitting.
4

Charging

The hearing instruments are pre‑charged on delivery.
They should have sufficient power for a first fitting
session.
We recommend to fully charge the hearing instruments
before first fitting and handover to the client. A full
charging cycle takes approximately 4 hours.
Follow the operating conditions in both the hearing
instrument's and the charger's user guide.

Connecting

Use Noahlink Wireless to fit the hearing instruments
wirelessly.
5