Briggs & Stratton RE 200 Serie Manual Del Operador página 16

A
B
Stopping the Rider
1. Move the ground speed control lever (D, Figure 4)
into the NEUTRAL position to make a gradual stop.
To make a more rapid stop, depress the clutch/brake
pedal (C).
NOTE: The ground speed control lever will return to
neutral from forward automatically when the clutch/
brake pedal is depressed.
2. Engage the parking brake by fully depressing brake
pedal and pulling up on parking brake knob (B).
3. Use the PTO switch to disengage the PTO.
4. Set the engine throttle to 1/2 throttle setting and allow
the engine to idle for 20 seconds. Stopping a hot
engine too fast may cause engine damage.
5. Turn key to OFF and remove it.
16
Mower Removal and Installation
NOTE: Perform mower installation on a hard, level sur-
face such as a concrete floor. For easier mower removal
and installation, rear trailing arms can be removed by
removing spring clips and clevis pins.
1. Park rider and turn off PTO switch and engine, remove
the key and apply parking brake. Turn the wheels fully
to the left.
2. On right-hand side of 30" mower, pull idler pulley arm
(A, Figure 6) to relieve belt tension (Note: 34" mower
shown).
3. With belt tension relieved, remove belt from idler pul-
ley (B) and PTO pulley (C). Removing belt relieves
tension on the front hitch assembly.
4. With lift lever down and Dial-A-Cut
lowest setting, remove lift cable (D) from mower hook
(see inset illustration, Figure 6).
NOTE: Pull back slightly on the lift lever to allow easier
turning of the Dial-A-Cut
5. Remove mower hitch (B, Figure 8) from rider hitch
Figure 5
brackets (C) by pulling spring-loaded lever (A) forward
and lifting up on hitch. Place mower hitch on ground.
6. With wheels turned fully left, remove mower from
underneath right-hand side of rider.
7. To install mower, reverse above steps. Check mower
belt pattern (as shown in Figure 7). Make sure that the
mower lift cable is installed with hook toward the rear
(see Figure 6 inset) and rear trailing arms (F, Figure 6)
are positioned above rear torsion bar.
control set to the
TM
control.
TM