Specifi Cations - Briggs & Stratton RE 200 Serie Manual Del Operador

Specifications
ENGINE
Briggs & Stratton
Model Intek Series OHV
Horsepower 14.5 Gross HP @ 3400 rpm
Displacement 31 cu in. (500 cc)
Electrical Alternator: 3 amp UN Reg.
Battery: 12 Volt, 195 CCA
Air Cleaner Pre-Cleaned Air to Paper Filter
Oil Capacity 48 oz (1,4 L)
TRANSMISSION
Make Hydro Gear T2-HP
Type Foot Pedal Hydrostatic
Lubrication Transmission is a Sealed Unit
Ground Speeds Infinite Forward: 0-5.0 MPH (0-8,05 km/h)
Reverse: 0-2.3 MPH (0-3,7 km/h)
Power Rating
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive
Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained
and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower
values are derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net
power values are taken with exhaust and air cleaner installed whereas gross power values are collected without these
attachments. Actual gross engine power will be higher than net engine power and is aff ected by, among other things,
ambient operating conditions and engine-to-engine variability. Given the wide array of products on which engines
are placed, the gas engine may not develop the rated gross power when used in a given piece of power equipment.
This diff erence is due to a variety of factors including, but not limited to, the variety of engine components (air cleaner,
exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (tempera-
ture, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Strat-
ton may substitute an engine of higher rated power for this Series engine.
Parts and Accessories
See an authorized dealer.
30
CHASSIS
Front Wheels Tire Size 13 x 5.00-6
Pneumatic Inflation Pressure 10 -12 psi
(0,68 - 0,82 bar)
Rear Wheels Tire Size 16 x 6.50-8
Pneumatic Inflation Pressure 10 -12 psi
(0,68 - 0,82 bar)
Fuel Tank Material: Non-Corrosive Polyethylene
Capacity: 2.0 Gallons (7,5 L)
Turning Radius Inside Rear Tire 12 in. (30.2 cm)
DIMENSIONS
Overall Length 61.0 in. (154,9 cm)
Overall Width 38.5 in. (97,8 cm)
Height 41.5 in. (105,4 cm)
Wheel Base 43.0 in. (109,2 cm)
Weight (approx.) 415 lbs (188,2 kg)