Briggs & Stratton RE 200 Serie Manual Del Operador página 24

Front-To-Back Leveling
1. Make sure mower is level side-to-side and that rear
rollers are on the ground.
2. Position blade(s) front-to-back. Measure the distance
from the ground to front tip of blade(s), and from
ground to rear tip of blade(s).
On 30" mower, the front tip should be level to 1/8"
(3 mm) higher than rear tip.
3. Loosen jam nut (E, Figure 25). To lower rear of mower
deck, loosen nut (B) which will lengthen leveling rod
(D). To raise rear of deck, shorten leveling rod. When
proper measurement is obtained, tighten nut (A)
against bracket (C), then tighten jam nut against nut.
24
Figure 24
*2399
Figure 25