Seat Adjustment - Briggs & Stratton RE 200 Serie Manual Del Operador

WARNING
To avoid serious injury, perform adjustments
only with engine stopped, key removed and rider
on level ground.

Seat Adjustment

Use the lever on the front of the seat (A, Figure 20) on to
adjust the seat forward or rearward for best rider comfort.
Steering Wheel Adjustment
Your unit is equipped with a dual position steering shaft to
allow for steering wheel adjustment for rider comfort.
1. Pull down on the rubber boot to expose the two holes
in the steering shaft (A, Figure 21).
2. Use a suitable drift to remove the roll pin at the base
of the steering wheel.
3. Align the hole in the steering wheel with the appropri-
ate steering shaft hole and install the roll pin.
NOTE: Steering wheel is factory installed with the roll pin
in the bottom hole.
22
A
A
Figure 20
Figure 21