Briggs & Stratton RE 200 Serie Manual Del Operador página 25

Transport Height Adjustment
Transport height should be adjusted so that rear mower
rollers are 1/8" - 1/4" (3-6 mm) above ground when
mower lift lever is in transport position. To adjust, perform
both mower leveling procedures first, then do the follow-
ing procedure.
1. Park rider on a flat level surface.
2. Adjust Dial-A-Cut control so that front edge of
TM
mower lift lever is aligned with 3" mark (30" mower) on
the quadrant scale.
3. Loosen nut (C, Figure 26) and position spacer (A)
against rear trailing arms (D). Position both the left
and right side spacers against trailing arms.
4. Tighten nut securely.
5. Place mower lift lever in transport position. Rear
mower rollers (B) should be 1/8" - 1/4" off ground. If
not, repeat Steps 2 - 4.
en
Figure 26
25