Tool Specifications; Angle Grinder; Noise/Vibration Information; Declaration Of Conformity - Würth EWS 18-A Manual De Instrucciones

13 Quick-clamping nut
14 Carbide grinding head*
15 Protection guard for cutting*
16 Cutting disc*
17 Hand guard*
18 Rubber sanding plate*
19 Sanding sheet*
20 Round nut*
21 Cup brush*
22 Button for charge-control indicator*
23 Battery charge-control indicator*
24 Handle (insulated gripping surface)
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.

Tool Specifications

Angle Grinder

Art. No.
Rated voltage
Rated speed
Grinding disc diameter,
max.
Thread of grinder spindle
Thread length (max.) of
grinder spindle
Weight according to
EPTA-Procedure 01/2003

Noise/Vibration Information

Measured sound values determined according to
EN 60745.
Typically the A-weighted noise levels of the product
are: Sound pressure level 82 dB(A); Sound power
level 93 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a
tainty K determined according to EN 60745:
Surface grinding: a =6.0 m/s
h
Disk sanding: a =2.5 m/s
h
The vibration emission level given in this information
sheet has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used to
compare one tool with another. It may be used for a
preliminary assessment of exposure.
EWS 18-A
0700 235 X
V=
-1
min
mm
mm
kg
(triax vector sum) and uncer-
h
2
, K=1.5 m/s
2 2
, K=1.5 m/s .
The declared vibration emission level represents the
main applications of the tool. However if the tool is
used for different applications, with different accesso-
ries or poorly maintained, the vibration emission may
differ. This may significantly increase the exposure
level over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the tool
is switched off or when it is running but not actually
doing the job. This may significantly reduce the expo-
sure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as: main-
tain the tool and the accessories, keep hands warm,
organise work patterns.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Tool Specifications" is in
conformity with the following standards or standardi-
zation documents: EN 60745 according to the provi-
sions of the directives 2011/65/EU, 2004/108/EC,
2006/42/EC.
18
Technical file (2006/42/EC) at:
10000 Adolf Würth GmbH & Co. KG, Abt. PFW
74650 Künzelsau
115
M 14
22
2.3
T. Klenk
General Manager
Künzelsau: 30.05.2012
❏ Use only the battery chargers listed on the
accessories page. Only these battery chargers
are matched to the lithium ion battery of your
power tool.
Note: The battery is supplied partially charged. To
2
, ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The Lithium-Ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
A. Kräutle
General Manager

Battery Charging

24