If No Picture Appears On Your Screen; Setup 7:Adjust The Tilt - Sony SDM-P234 Manual De Instrucciones

Ocultar thumbs Ver también para SDM-P234:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 81

If no picture appears on your screen

• Check that the power cord and the video signal cable are
properly connected.
• If "NO INPUT SIGNAL" appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by touching
INPUT (page 11).
• If "CABLE DISCONNECTED" appears on the screen:
– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by touching
INPUT (page 11).
• If "OUT OF RANGE" appears on the screen, reconnect the old
monitor. Then adjust the computer's graphics board within the
following ranges.
Analog RGB
Horizontal
28–92 kHz
frequency
Vertical
48–85 Hz
frequency
1600 × 1200 or more*
Resolution
1920 × 1200 or less
* Only when the vertical frequency is set to 60 Hz.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 22.
No need for specific drivers
The monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed on the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency is set to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
10
Digital RGB
28–75 kHz
60 Hz

Setup 7:Adjust the tilt

This monitor can be adjusted within the angles shown below.
Grasp the sides of the LCD panel, then adjust screen
angles.
approx.
175°
approx. 175°
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.
Note
When adjusting the screen tilt, proceed slowly and carefully, being sure
not to hit the monitor against the desk.
approx.
approx.
30°

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido