Broan Best PIK33 Manual De Instrucciones página 12

21. USE AND CARE
Don't (cont'd):
- Do not allow dirt to accumulate.
- Do not let plaster dust or any other construction residues reach the insert. During construction or
renovation, cover the hood to make sure no dust sticks to stainless steel surface.
Avoid: when choosing a detergent
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing : chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are
highly explosive and should never be used close to a range.
22. OPERATION
Always turn your blower on before you begin cooking to establish an air flow in the kitchen. Let the blower
run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner
and brighter.
The insert is operated using the (3) slide controls located beneath the front edge of the insert or the WCPI
optional wall control.
HE0019
1) Light switch
2) Blower speed control
3) Blower ON/OFF switch
COOKTOP LIGHTING (HALOGEN)
The light switch turns the halogen lights ON and OFF.
Use PAR 20, 50W halogen bulbs (Purchase separately).
BLOWER
The blower is operated using two (2) controls.
Use the blower speed control to increase or decrease cooktop ventilation. Slide the control to the left to
increase the blower speed - to the right to decrease the blower speed.
The blower ON/OFF switch turns the blower ON to the speed pre-set by the speed control. The blower must
be turned On and OFF using this switch.
HEAT SENTRY™
This unit is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will turn on or speed
up the blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting – it turns the blower up to HIGH speed.
The HEAT SENTRY™ can start the blower even if the insert is turned OFF. In this case, it is impossible
to turn the blower OFF with blower switch. If you must stop the blower, do it from the main
electrical panel.
When the temperature level drops to normal, the blower will return to its original setting.
Test all insert switches. If a WCPI remote control is installed, test all its switches.
Finalize the custom hood.
(CONT'D)
1
WARNING
!
2
- 12 -
3