Broan Best PIK33 Manual De Instrucciones página 6

6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table
below to find the right liner model number for your insert and width of custom hood. To view specific model
information, including depths for each liner models, visit www.bestbybroan.com or contact Technical support
(phone number listed on page 14, in warranty text). To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner
piece, assemble insert, and reassemble front liner piece.
LINER MODEL INSERT MODEL
L3336, L3336S PIK33
L3342, L3342S PIK33
L4548, L4548S PIK45
L4560, L4560S PIK45
7. INSTALL THE WCPI REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located
in front of the insert. Perform this connection before the
insert installation. For installation details, see installation
instructions included with the WCPI remote control.
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet,
using the dimensions shown beside.
INSERT MODEL NUMBER
PIK33
PIK45
NOTES: 1. The notch shown in the inset must be cut only if
the WCPI optional remote control will be installed.
2. The recommended distance from the back to the
rearmost cutout edge is 2 1/4'' minimum.
9. INSTALL BLOWER (EXTERIOR OR INTERIOR)
INTERIOR BLOWER: Follow all subsequent steps of this manual.
EXTERIOR BLOWER: Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17,
19 and up of this manual.
CUSTOM HOOD
NOMINAL WIDTH
36''
42''
48''
60''
HA0038A
HL0044
A
32 1/2''
44 1/2''
- 6 -
3 1/2''
17 1/16''
2 1/4''
A
min.
HD0084
16 3/8''