Select Blower Option And Install Ductwork; Prepare The Installation - Broan Best PIK33 Manual De Instrucciones

1. SELECT BLOWER OPTION AND INSTALL DUCTWORK

Either an interior or exterior blower may be used with this insert. The insert model PIK33 or PIK45 must be
installed with blower models P5, P8, EB6, EB9, EB12 or EB15 only. Other blowers cannot be substituted.
(Blowers sold separately).
Plan where and how the ductwork will be installed. Access to the top of the hood is preferred for connection
of ductwork. As an alternative, flexible metal ductwork may be used.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use round
ductwork, with a short section (about 4' expanded) of flexible metal duct (optional) for attachment to the
transition. Use screws to attach flexible metal duct to the rigid duct. Use 2" duct tape to seal duct joints.
The minimum hood distance above cooktop must not be less than 24". A maximum of 30" above
cooktop is highly recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion.
Roof cap
7" or 8" round ducts
with 7" or 8" round
metal flex. duct (optional)
3 1/4" x 10" to 7" or 8" transition
or 3 1/4" x 14" to 8" transition
Insert with
Wall
interior blower
cap
24" minimum
above cooking surface
HH0038A
MODEL P5 (SINGLE) OR P8 (DOUBLE)
INTERIOR BLOWER TYPICAL DUCTWORK

2. PREPARE THE INSTALLATION

Make sure that the following items are included:
- Insert
- Accessories:
• Baffle filters (3 for PIK33 model, 4 for PIK45 model)
• Chrome rings for lights (2 for PIK33 model, 3 for PIK45 model)
• Bag of parts including:
(4) lock nuts, (1) wire clamp, (8) #8 x 3/4" standard screws, (2) wire connectors,
(2) #6 x 1/2" standard screws, (8) #8 x 3/8" screws. Discard items not used.
Parts sold separately:
- Interior blower Model P5 includes blower, rough-in kit, flow deviator and 3 1/4" x 10" adapter
- Interior blower Model P8 includes blower, rough-in kit, flow deviator and 3 1/4" x 10" adapter
and 3 1/4" x 14" adapter
- Exterior blower assembly EB6, EB9, EB12 or EB15 (all include rough-in plate)
- Halogen lights (120V, 50W, PAR 20)
- Custom hood liner Model L3336, L3336S, L3342, L3342S, L4548, L4548S, L4560 or L4560S (optional)
- Ambient light panel Model ALP30, ALP36, ALP42, ALP48 or ALP60 (optional)
- Backsplash RMP Series (optional)
- WCPI Remote control (optional)
- Transitions, ducts (rigid and flexible), elbows, dampers, wall and roof caps. Refer to page 3 for a complete
list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
Exterior blower
HH0039A
MODEL EB6, EB9, EB12 OR EB15 EXTERIOR
BLOWER TYPICAL DUCTWORK
- 4 -
10" round duct
10" round metal flex. duct
(optional)
Insert with
exterior blower
24" minimum
above cooking surface