Technical Data - Derby cycle Focus Manual Del Usuario

English–2
Indication Elements, Drive HMI
a Speed indication
b Light indicator
c Assistance-level indicator
d Start-assistance indicator
e Multi-function indicator
f Assistance-mode and error code indicator
g Battery charge control indicator

Technical Data

Drive Unit
Article number
Rated continuous
output
Output torque, max.
Rated voltage
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Drive HMI
Article number
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery in all country-spe-
cific versions, depending on the statutory regulations
0 276 001 X45 | (28.9.11)
Drive Unit 45
0 275 007 003
W 350
Nm 50
V= 36
°C –5...+40
°C –10...+50
IP 54 (dust and
splash water
protected)
kg 4
HMI
1 270 020 900
°C –5...+40
°C –10...+50
IP 54 (dust and
splash water
protected)
kg 0.15
V= 6
W 2.7
W 0.3
Assembly
Inserting and Removing the Battery
For inserting and removing the battery in/from
the the eBike, please read and observe the bat-
tery operating instructions.
Positioning the Holder of the Drive HMI
Tighten screws 10 and 9 with a tightening
torque of 1 Nm (max.). Otherwise, the hold-
er 2 can become damaged.
Moving/Tilting the Holder (see figure A)
Loosen both screws 9 on the bottom side of
holder 2. Move the holder on the handlebar or
change the holder angle. Retighten both screws
9 again with a tightening torque of 1 Nm (max.).
Turning the Holder (see figure B)
Loosen screw 10 on the top side of holder 2.
Turn the top part of the holder in such a manner
that the drive HMI 1 is well in your view after in-
serting it (see "Inserting and Removing the Drive
HMI"). Retighten screw 10 again with a tighten-
ing torque of 1 Nm (max.).
Inserting and Removing the Drive HMI
(see figure C)
To insert the drive HMI, place it turned by approx.
30° onto holder 2 and then turn it clockwise to
the stop.
To remove the drive HMI, turn it approx. 30°
anticlockwise and pull it out of the holder 2.
Remove the drive HMI when parking the
eBike, so that the drive cannot be used by
unauthorised persons. Without the drive
HMI, the drive cannot be switched on.
Bosch eBike Systems