Check Weighing (Default) - Uline OHAUS DEFENDER 5000 Manual Del Usuario

ACCUMULATION
See Weighing section on page 13 for details about the
Accumulation feature.
INPUT/OUTPUT (I/O) SETUP
The I/O's setup can be customized for various user
preferences defined below.
ITEM AVAILABLE SETTINGS
Enable On, Off
Discrete Input 1 Off, Zero, Tare, Clear Tare, Print, Unit Accumulate
Discrete Input 2 Off, Zero, Tare, Clear Tare, Print, Unit Accumulate
Discrete Output 1 Off, Overload, Underload
Discrete Output 2 Off, Overload, Underload
Discrete Output 3 Off, Overload, Underload
Discrete Output 4 Off, Overload, Underload
NOTE: Default settings are in bold.
NOTE: The I/Os will only work when the I/O
Option Board has been installed. The option
I/O board provides two isolated inputs and four
dry-contact normally open relay outputs which
can be used for simple process weighing.
1. Press the button to enter the Main Menu.
User
Menu
2. With the button
corresponding to
the ▼ icon, go down
the list and highlight
Application Mode.
Enter this submenu by
pressing the button corresponding
to the icon. (See Figure 53)
3. In the Application
Mode menu, enter the
Counting submenu.
(See Figure 54)
4. Select the list item
and press the button
corresponding to the
icon to change the
setting as desired. After
completion of I/O's
setup, press the softkey corresponding to the
icon to return to the main application screen.
(See Figure 55)
PAGE 16 OF 101
APPLICATIONS CONTINUED
Figure 53
Figure 53
Figure 54
Figure 55
CHECK
Check is used to compare the weight or pieces of a
sample against target limits.
Press the button until the icon corresponding to
Library
Mode
Check is displayed on the screen.
Two different modes can be selected in the check
mode: Weighing and Counting.
To set up check limits, see Check Weighing below.
Place object on pan to check if weight is within limits.

CHECK WEIGHING (DEFAULT)

Make sure that the check mode is set to Check
Weighing in the configuration menu.
Place objects on pan. The
Under/Accept/Over status
is shown in the progress
bar area, while the actual
weight of the item is shown
on the main display line.
(See Figure 56)
Defining Over/Under Limits
1. Press the Edit Limit button to define limit for weighing.
2. Select Over or Under
Limit and press the
button corresponding
to the icon to edit
value. (See Figure 57)
Figure 56
Figure 57
0621 IH-8105