Check Weighing - Uline OHAUS EXPLORER H-4737 Manual Del Usuario

The Edit Settings screen shows current Reference Adjust
value. To change it, touch REFERENCE ADJUST button.
1. A numeric window appears. Key in the desired
Reference Weight Adjustment, then press √.
2. The display returns to the previous screen with the
new value highlighted momentarily. To return to the
Percent Weighing home screen, touch RETURN TO
APPLICATION.

CHECK WEIGHING

Check weighing is used to compare the weight of a
sample against target limits. Three different modes can be
selected: Over and Under, Nominal Weight Tolerance, or
Nominal Percent Tolerance.
STANDARD CHECK WEIGHING (DEFAULT)
1. In the upper left portion of the home screen, select
CHECK WEIGHING.
2. The default (or last) check weigh limits are displayed.
Place objects on the pan. The Under/Accept/Over
status is shown in the progress bar area while the actual
weight of the item is shown on the main display line.
EDIT SETTINGS
To view or adjust the current settings touch the EDIT
SETTINGS button. The Settings screen appears:
• Settings available: Over Limit, Under Limit
• Functions available: Return to Application
PAGE 12 OF 96
OPERATION CONTINUED
3. The check limit values are displayed in the settings screen.
4. A numeric input window appears. Enter the desired limit
5. The display returns to the previous screen with the new
CHECK WEIGHING – NOMINAL/WEIGHT TOLERANCE MODE
With this feature you can establish a Target or Nominal
weight value and pre-set tolerance in weight.
1. To enable this feature, enter the setup menu.
2. Change the mode to Nominal, wt. Tolerance. The
• To set the over limit value, touch the OVER LIMIT button.
To set the under limit value, touch the UNDER LIMIT button.
weight, then press √.
value highlighted momentarily. To return to the check
weighing home screen, touch RETURN TO APPLICATION.
Check Weighing options screen returns.
0721 IH-4737