How To Stop The Turbo-V 750/850 Twistorr Pumping System - Agilent Technologies Turbo-V 750 Manual De Instrucciones

16 Instructions for Use
Use of Turbo-V 750/850 TwisTorr Pumping System
In order to maintain the IP-54 protection level you must use only the connectors
NOTE
provided with the pump. Use connectors PN: 969-9957 or 969-9958 for the
power cable. Use this cable and plug together with a properly grounded plug to
prevent electric shocks and to comply with EC Standards.
How to Stop the Turbo-V 750/850 TwisTorr
Pumping System
To stop the pump you can use one of the following methods:
1
2
3
WARNING! The Turbo-V 750/850 TwisTorr Pumping System Power Supply (969-6521)
must be powered with 3-wire power cord (see para. "ACCESSORIES AND
SPARE PARTS" in the annex "Technical Information") and plug
(internationally approved) for user's safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical shock
and to satisfy CE requirements. High voltage developed in the controller can
cause severe injury or death. Before servicing the unit, disconnect the input
power cable.
300/406
Unplugging the provided mating I/O connector
Giving a remote stop signal through the I/O connector (see para.
"J1-REMOTE I/O" of annex "Technical Information")
Giving a remote stop signal via the serial RS 232/485 interface
(see para. "RS232/RS 485 Communication Description" of annex
"Technical Information").
Turbo-V 750/850 TwisTorr User Manual / 87-901-020-01 (A)