Abicor Binzel Robo Instructivo De Servicio página 24

12 Disposal
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
EN - 12
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the compressed air supply.
• Switch off the entire welding system.
NOTE
• Observe the information given in section 8 Putting out of operation on
page EN-10.
For disposal, observe the local regulations, laws, provisions, standards and
guidelines. For the product to be properly disposed of, it first must be
dismounted.
 See 11 Dismounting on page EN-11
This product is mainly made of metallic materials which can be melted in steel
and iron works and are, thus, almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
Oil, grease and cleaning agents must not contaminate the ground or enter
sewage systems. These materials must be stored, transported and disposed of
in suitable containers. Observe the relevant local regulations and disposal
instructions of the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the manufacturer
of the consumables.
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
Air-blast and injection unit