Troubleshooting - Abicor Binzel Robo Instructivo De Servicio

Air-blast and injection unit

10 Troubleshooting

Fault
No spraying function
Spraying function is
not switched on/off
Air-blast and injection
unit leaks
Tab. 6 Troubleshooting
11 Dismounting
NOTE
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
NOTE
• If the measures described below are not successful, please consult your
dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as power source, welding torch system.
Cause
• Check level!
• Hose connections open.
• Air-blast hose kinked.
• Output signal is active.
• Solenoid valve does not work.
• Screws loose
• Improper mounting
Dismounting may only be carried out by specialised personnel. Please make
sure that the shutdown procedures are strictly observed before the dismounting
is started. Make sure to include also the components integrated into the
welding system.
10 Troubleshooting
Solution
• Refill anti-spatter agent.
• Close the compressed air supply.
• Check hose guide.
• Check system control.
• Replace solenoid valve, if
necessary, and check the control
lead.
• Retighten; replace seals if
necessary (seal kit 832.0044)
• Mount without vibration and
according to specifications.
EN - 11