Galletti MYCOMFORT LARGE Manual Del Usuario página 45

MYCOMFORT LARGE
In order to bring the humidity to the set value, the fan (and valve, if present) will be
activated even if the room temperature has already reached the programmed setpoint
(indicated on the display). Should the room temperature fall too far below this
threshold, the logic will be temporarily inhibited.
WATER CONTROL
Enabling of the dehumidification function is tied to the water temperature. The related
enabling logic is described below
If enabling conditions do not exist, the dehumidification function will be temporarily
inhibited. The same will occur in the event that the sensor is disconnected.
NB: once the target level of humidity is reached or the controller is switched off, the
dehumidify option will be unselected
DISPLAY
The display shows the following information
> Dehumidify ON: symbol lit
> Dehumidification temporarily inhibited: flashing symbol
PROGRAMMING OF TIME SCHEDULES
GENERAL FUNCTIONING
Time schedules are programmed by setting the dedicated parameters (H parameters)
in a suitable manner and in the correct sequence. The procedure for accessing
parameters and the meaning of each parameter are thoroughly described in the
paragraphs below. It is possible to set two different types of time schedules:
- ON/OFF time programming: each time slot can be associated with a controller
ON or OFF status, so that the controller will automatically switch on or off according
to the time of day.
- temperature SETPOINT programming according to time of day: each time slot can
be associated with a SUMMER temperature SETPOINT (for cooling) and a WINTER
temperature SETPOINT (for heating), which will be automatically used by the
controller as the temperature SETPOINT (adjustable by the user within a range
of ±2°C) according to the time of day and current operating mode.
Two daily profiles can be defined, each of which divided into three time slots. Each
day of the week can be associated with one profile or the other.
È severamente vietata la riproduzione anche parziale di questo manuale / All copying, even partial, of this manual is strictly forbidden
DAILY PROFILE 1 (FIGURE 9):
WHERE:
A SLOT 1
B SLOT 2
C SLOT 3
DAILY PROFILE 2 (FIGURE 10):
A SLOT 1
B SLOT 2
C SLOT 3
AIR TEMP. ACCESS TO PARAMETER CONFIGURATION PROCEDURE
- Push the and at the same time
WATER
TEMP.
> Use keys
"5", and press
- Use keys
list")
. Press
- use keys
. Press
- after completing the modification of the parameters concerned press key
exit the procedure
45
and
to modify the display value up to the password value
. If it is correct, you will have access to the parameters.
to scroll the various parameters (see "Parameter
to confirm the parameter change (the value will start flashing)
to change the value
to save the new value setting or
GB
to cancel the modification
to
FC66002638 - rev. 05