Setting You Recipe - JAC TRADILEVAIN TL40 Traducción Del Manual De Uso Original

7.2 Setting you recipe

The Tradilevain has two recipe modes:
-
Automix® recipe: Agitation will not take place unless the increase in starter volume has
exceeded the percentage you have specified. Interim agitation will take place if overflow is
imminent.
The Tradilevain operates in automatic mode.
OR
-
Cyclical recipe: Throughout the cycle, agitation takes place at a predefined rate for each stage
(fermentation, falling in storage, storage). Interim agitation will take place if overflow is imminent.
It should be noted that recipes 1 (cyclical) & 2 (Automix) are locked (factory). They can be used, looked up or
copied, but cannot be edited.
For simplified commissioning and use, we advise you to use the standard Automix recipe and
go on directly to stage "
Copying, editing and using an Automix® recipe:
A. Press the "recipes" key.
B. Press the Automix® recipe
C. Enter the recipe password (2633).
D. Press the "copy recipe" key.
E. Press the intended recipe.
F. Press the "use recipe" key.
It should be noted that the recipe framed in red is the recipe activated for the cycle.
G. Press the "edit recipe" key.
H. Set your feed time of day.
I. Set the time for the first agitation of the mix.
J. Set the pause time between mix agitations.
K. Set the time for the second agitation of the mix.
L. Press the "fermentation" tab.
M. Set the fermentation temperature.
N. Set the fermentation time.
O. Set agitation time during fermentation.
P. Set fermentation percentage before triggering an agitation.
Q. Press the "storage" tab.
R. Set storage temperature 1.
S. Set storage temperature 2. (storage 2 is triggered automatically 24 hours after feeding). Storage
temperature 1 enables the sourdough starter to be stored for daily feeding whereas storage
temperature 2 enables the starter to be stored up to 72 hours without feeding. It is inadvisable to set
a storage temperature below 8 °C (46 °F) in order to preclude any risk of freezing on the tank
wall.
T. Set the agitation barring time before feeding time.
U. Press the "speed" tab.
V. Set agitation speed low level during mixing.
W. Set agitation speed high level during mixing.
X. Set stirring speed during heating.
Y. Set stirring speed during cooling.
Z. Set agitation speed low level during fermentation and storage.
AA. Set agitation speed high level during fermentation and storage.
BB. Return to home screen, your recipe is ready.
3 – Start Feed
".
(fig.9, 10)
9