APRILIA eSR2 Manual Del Usuario página 11

NOTICE
The vehicle is delivered folded and with the handlebar removed.
Steps:
1. Open the kickstand
2. Unfold the handlebar tube and secure it with the locking hook
3. Install the handlebar on the rod (beware not to flatten the wires)
4. Insert the screws inside into the hole located under the control panel
5. Tighten the screws with the hexagonal key provided
6. Try to turn the e-scooter ON/OFF.
7. Charge the battery to 100%
8. Adjust the folding mechanism**
9. Adjust the braking system (chapter 9)
10. Check the tyre pressure (36 PSI)*
*If the scooter has not travelled at least 60% of the stated km or reached the maximum
speed in the first 3 months of use, it is likely that the wheels have deflated again, it will thus
be necessary to restore the pressure as indicated (36 PSI).
** If the handlebar rod is loose, you can tighten the screw on the folding system lever.
6. Assembly and configuration
09