APRILIA eSR2 Manual Del Usuario página 36

WARNING
Read the manual and instructions below in full before using the product.
Product name: eSR2
Product type: Electric scooter
Year of production: 2021
Note:
• To recharge this electric scooter use ONLY the supplied charger labelled
• HLT-180-4201500 with the following output voltage: 41.5V–1.5A.
• Using another type of charger can damage the product or pose other potential risks.
• Never leave the product to charge unsupervised.
• The charging time of the product must not exceed four hours. Stop charging after four
hours.
• The product should only be charged at temperatures between 0 °C and 40 °C.
• If charged at lower or higher temperatures, there is a risk that the battery will offer
reduced performance, potentially resulting in damage to the product and personal injury.
• The product must be used only at temperatures between -10 °C and 40 °C.
• If used at lower or higher temperatures, there is a risk that the battery will offer reduced
performance, potentially resulting in damage to the product and personal injury.
• Store the product at temperatures between 0 °C and 35 °C (the optimum storage
temperature is 25 °C)
• Recharge and store in a dry and open place, away from combustibles (i.e. any flammable
element).
• Do not recharge in sunlight or near open flames.
• Do not recharge the product immediately after use. Allow the product to cool for an hour
before charging.
• If you are away for a certain period of time, for example for holidays, and you entrust
the device to a third party, leave it in a partially charged state (20–50% charge). Not fully
charged.
• The product is often supplied partially charged. Leave it in this state until it is ready to be
used.
34