Battery Maintenance; Transporting Machine; Storing Machine; Recommended Stock Items - Nobles Speed Scrub 2401 Manual Del Operador

Ocultar thumbs Ver también para Speed Scrub 2401:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION

BATTERY MAINTENANCE

WARNING: Keep sparks and open flame
away. Keep battery compartment open when
charging.
FOR SAFETY: When servicing machine, wear
protective gloves when handling batteries and
battery cables. Avoid contact with battery acid.
1. Always follow proper charging instructions
(See BATTERY CHARGING).
2. After charging, check fluid level (A) in each battery
cell of all batteries. The level should reach bottom
of sight tubes (B). If needed, add just enough
distilled water to reach bottom of sight tubes. DO
NOT overfill (Figure 33).
B
A
FIG. 33
3. Keep battery tops and terminals clean and dry.
To clean batteries:
a. Mix a strong solution of baking soda and
water.
b. Brush solution sparingly over battery tops,
terminal and cable connectors.
NOTE: Do not allow baking soda solution to enter
battery cells.
c. Use wire brush to clean terminal post and
cable connections.
d. After cleaning, apply a coating of clear battery
post protectant to terminals and cable
connections.
4. Check for loose or worn cables. Replace if worn.

TRANSPORTING MACHINE

When transporting machine by use of trailer or truck,
be certain to follow tie–down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Remove squeegee from machine and raise scrub
head. Leave pad or brush installed.
2. Load machine using a recommended loading
ramp.
18
Home
Find... Go To..
3. Position front of machine up against front of trailer
or truck. Once machine is positioned, lower brush
head.
4. Place a block behind the drive wheel and the rear
casters.
5. Place tie–down straps over top of machine and
secure straps to floor. It may be necessary to
install tie–down brackets to the floor of your trailer
or truck.

STORING MACHINE

1. Before storing machine, be certain to flush tanks
and drain machine of all water.
2. Store machine in a dry area with squeegee
removed and pad driver in the raised position.
3. Remove recovery lid to promote air circulation.
4. When storing machine, raise pad scrub head and
squeegee off floor to prevent damage.
ATTENTION: If storing machine if freezing
temperatures, be certain to drain machine of all
water. Damage due to freezing temperatures is not
covered by warranty.
ATTENTION: Do not expose machine to rain; store
indoors.

RECOMMENDED STOCK ITEMS

Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
Speed Scrubt 2401/2601 (07–02)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido